1.      Container Inspection:

Check for any damage on the containers such as holes in the walls or in the roof, gaps or holes in the floor.Doors should close tightly, and rubber seal must be in good conditions Containers should be clean and dry before loading

2.      Check the moisture content of container floors.

If possible do not use containers with over 20% moisture content.If this is not possible, adjust the number of AbsorbTech units used as given in usage instructions. Do not use container with floors with moisture contents in excess of 25%.

3.      Seal air vents

4.      Remove AbsorbTech units from plastic bag

5.      Hang the units from securing points on container side walls just under roof

6.      Close the container doors

If there is a very tight fit in container, AbsorbTech Pole/Sac/Bag units may be laid flat on top of cartons. However hanging should be appropriate for the vast majority of containers